The Rose Corporation was tasked with fabricating and machining enclosures, brackets, and baseplates for multiple units used in industrial and municipal settings. These units require a sturdy, air-tight enclosure to ensure operational efficiency as well as safety. The base plate consists of a 316 stainless steel plate and sheet, as well as A36 carbon steel. Shearing, plate […]
The team at The Rose Corporation recently completed the inspection and replacement of the wear bars on two existing 22-1/2 Ton Ladle Lifting Hooks for a local Steel Mill. The job requirements included: The inspection of hooks for any loose rivets, which we then removed and replaced if required. The removal of worn wear bars
The Rose Corporation donated labor and materials to construct a steel door frame and base for The Reading Fire As part of our mission to serve our community, The Rose Corporation donated labor and materials to construct a steel door frame and base for The Reading Fire Department Fire Fighter Training Program. The Reading Eagle
The Rose Corporation has extensive experience fabricating charging buckets for steel manufacturers. Charging buckets are used to load scrap into an electric arc furnace. Charging buckets are sized by volume and diameter. A charging bucket is transported by an overhead crane using its main hook. It uses a special lifting bale that is opened and
Fabricating Charging Buckets For Specialty Steel Manufacturing Read More »
Recycling aluminum takes only 5% of the energy used to make new aluminum from bauxite ore. Approximately 30% of the aluminum produced in the US is from recycled scrap, used beverage containers being the largest component. Dross is the mass of solid impurities floating on the molten aluminum when it is being melted. That’s where
After years of using the A.O.D. Vessel under extreme heat conditions by a local specialty steel mill, the center main body bulged out of round by as much as 3-inches making it impossible to fit into the trunnion ring that supports it. We were contracted to replace the center section (1-1/2” thick steel cylinder) Time was of
The Rose Corporation manufactured one 14′-0 Diameter and one 11′-0 Diameter replacement “Water Cooled Roof Rings” for use on Electric Arc Furnaces (see diagram below, Item 8). A continuous flow of water enters the water jacket, circulates the entire ring, and exits in order to keep the roof section of the Electric Arc Furnace cool.
The Rose Corp has fabricated numerous Stainless Steel 304 Frames from structural steel shapes,angles, channels, bars and pipes per attached photos. They range in size roughly 6’ x 6’ x 12’ to 6’ x10’ x 15’ The frames resemble “Shark Cages” and are used in waste water treatment plants.AccuWeb material is stretched continuously from pipe
A thermal oxidizer is a type of air pollution control equipment used in manufacturing and other industrial processes to reduce emissions of harmful air pollutants such as volatile organic compounds. The Rose Corporation has extensive experience building air pollution control systems for manufacturing applications. Over the last 20 years, we have built approximately 100 Regenerative Thermal Oxidizers in
Among the large-scale steel and aluminum components regularly manufactured at the Rose Corporation are 90-Ton melting kettles used to process lead into a molten lead for the battery industry. Lead batteries are used for a vast number of purposes, but all batteries provide either starting, for instance starting a car, or deep cycle power used
The Rose Corporation specializes in large-scale, complex, steel industrial fabrication and contract manufacturing. Our team of highly skilled fabricators and machinists have extensive experience manufacturing heavy industrial components and have built a reputation for delivering the highest quality work on time and within budget.
